I had to trim an accelerometer mounting (triaxial accel - 2 leg magnet with no through-hole) using shim washers from good ol' McMaster-Carr. I wonder if these could be a source for the needed 1/32 washer? My question pertains mainly to the Sport division, but I was wondering what would be the optimum launch rod length for 1/8th and 3/16th diameter rods? I have the old standard Estes two piece rods AND a 4' length of one piece in both sizes. Seems the Estes rods aren't long enough to accomodate. I buy most funky hardware from McMaster-Carr since they have everything, and it is one day shipping. This is not the budget choice, however. Their Terminal blocks seem fine to me after you cut off the bottom stand offs. Anything you can get on McMaster is available elsewhere, as far as I know. The difference is that a) McMaster has instashipping. b) McMaster has nearly everything, so it's one-stop shopping. c) McMaster has a lovely, easily navigable website. d) You don't always know exactly what you will get from McMaster; they don't show brand names or the like. This applies more for equipment and specific. I've been working on making a video for Wildman with some build instructions for the Mach 2 kit. I used the provided Proline 4500 to tack the fins and for fillets. I'm a bit messy with it but, hey, everything's sticking and (relatively) level, right? Braden I'm also using a specific part from McMaster Carr for the wing pivot assembly. There's a bit of the backstory on why I mentioned in my first post that I've been waffling some. So i have an edgestar outdoor kegerator with a 2 tap chrome tower. I have 2 perlick faucets attached. My problem, is that 1 of the faucet's leaks. When i pour a beer from my right faucet, the left faucet leaks a little bit of beer out. The bigger issue, is that sometimes, when the outdoor. Ive ben ordering from mcmaster carr for years and years thanks to my dozens of other hoppies in addition to brewing. Their shipping charges are always pretty decent. Unless I order something heavy or oversized, its usually about 5.50 shipped from NJ to long island. You could always call them or email customer service and find out before you order. I just ordered a launch rail from McMaster-Carr, having heard of them here on TRF. I kept looking for a listing of shipping charges, but didn't find it. When I clicked through, I found that I had placed my order, and never got a shipping charge notice. It's not even on my email confirmation or.